Tips to Get the Best Decorative Concrete
Stamped concrete can be a beautiful addition to any property. However, if it is poorly done, it will turn out badly for you and the contractor as well. During the process of stamping, it is vital that there are no spots left unattended to because these issues will only be noticed after the process is all done. This is why you need a contractor that has experience because they have probably been in these scenarios and they know how to prevent them. We have listed below some of the tricks you could use to make sure that you achieve the best textures. It is important to make sure that you stamp as early as possible. You do not need a tamper as you will need to just walk on the stamps into the surface if you start stamping early.
The next useful tip you could use is setting the retarders and slow evaporation. It is possible to assume that the slab has already become hard enough just because you can see that it has crusted. However, once you start stamping on the surface, you will realize that you are sinking because the crust is cracking. The reason why you apply the evaporation retarder is so that the surface dries well. Retarders usually slow down the evaporation process so that you the slab is properly textured.
The slab needs to be crawled as the next step. Just before you start with the stamping, you will need to send people out on kneeboards. The vigorous floating of the slab as well as the weight will ensure that the surface is worked up. Stamping becomes easier because the slab will be having the same consistency throughout. If you want dramatic results, this is the way to do it. In the case you have the slab getting ahead, all you need to do is use a roller on the surface. Getting texture is easier this way.
You can wear textured shoes as great tools for you to stamp the slab. These shoes are held into place by friction and the best part is that you do not have to deal with any straps or buckles. You will easily walk over the concrete without sinking since the weight of the wearer spreads over a large area. You should start stamping from the middle going towards the outside. This technique ensures that there are no different textures on the slab and the stamping will be more uniform this way at both ends. However, you will need to have more stamps than normal if you go with this approach but you will have consistent texture throughout.